Linux version 2.4.27-1-386 (joshk@trollwife) (gcc version 3.3.4 (Debian 1:3.3.4-9)) #1 Fri Sep 3 06:24:46 UTC 2004 BIOS-provided physical RAM map: BIOS-e820: 0000000000000000 - 000000000009f800 (usable) BIOS-e820: 000000000009f800 - 00000000000a0000 (reserved) BIOS-e820: 00000000000dc000 - 0000000000100000 (reserved) BIOS-e820: 0000000000100000 - 000000001e6f0000 (usable) BIOS-e820: 000000001e6f0000 - 000000001e6ff000 (ACPI data) BIOS-e820: 000000001e6ff000 - 000000001e700000 (ACPI NVS) BIOS-e820: 000000001e700000 - 000000001e800000 (reserved) BIOS-e820: 00000000fff80000 - 0000000100000000 (reserved) 486MB LOWMEM available. On node 0 totalpages: 124656 zone(0): 4096 pages. zone(1): 120560 pages. zone(2): 0 pages. ACPI: RSDP (v000 PTLTD ) @ 0x000f8170 ACPI: RSDT (v001 PTLTD RSDT 0x06040005 LTP 0x00000000) @ 0x1e6fae47 ACPI: FADT (v001 PTLTD RSDT 0x06040005 PTL 0x000f4240) @ 0x1e6fedd6 ACPI: SSDT (v001 PTLTD ACPICST1 0x06040005 LTP 0x00000001) @ 0x1e6fee4a ACPI: SSDT (v001 PTLTD ACPIPST1 0x06040005 LTP 0x00000001) @ 0x1e6fef06 ACPI: DSDT (v001 PTLTD DSDT 0x06040005 MSFT 0x0100000e) @ 0x00000000 Kernel command line: root=/dev/hda6 ro No local APIC present or hardware disabled Initializing CPU#0 Detected 994.507 MHz processor. Console: colour VGA+ 80x25 Calibrating delay loop... 1979.18 BogoMIPS Memory: 487160k/498624k available (1065k kernel code, 11076k reserved, 457k data, 96k init, 0k highmem) Dentry cache hash table entries: 65536 (order: 7, 524288 bytes) Inode cache hash table entries: 32768 (order: 6, 262144 bytes) Mount cache hash table entries: 512 (order: 0, 4096 bytes) Buffer cache hash table entries: 32768 (order: 5, 131072 bytes) Page-cache hash table entries: 131072 (order: 7, 524288 bytes) CPU: L1 I Cache: 128K (64 bytes/line), D cache 64K (32 bytes/line) CPU: L2 Cache: 1024K (128 bytes/line) CPU: Processor revision 2.0.0.0, 1000 MHz CPU: Code Morphing Software revision 6.0.4-1-62 CPU: 20040723 20:41 official release 6.0.4#6 CPU: After generic, caps: 2fcbf9ff 01d3f1ff 0000142a 00000000 CPU: Common caps: 2fcbf9ff 01d3f1ff 0000142a 00000000 CPU: Transmeta Efficeon(tm) Processor TM8000 stepping 04 Enabling fast FPU save and restore... done. Enabling unmasked SIMD FPU exception support... done. Checking 'hlt' instruction... OK. Checking for popad bug... OK. POSIX conformance testing by UNIFIX ACPI: Subsystem revision 20040326 ACPI: Interpreter disabled. PCI: PCI BIOS revision 2.10 entry at 0xfd8ac, last bus=2 PCI: Using configuration type 1 PCI: Probing PCI hardware PCI: ACPI tables contain no PCI IRQ routing entries PCI: Probing PCI hardware (bus 00) PCI: Using IRQ router ALI [10b9/1563] at 00:03.0 Linux NET4.0 for Linux 2.4 Based upon Swansea University Computer Society NET3.039 Initializing RT netlink socket Starting kswapd VFS: Disk quotas vdquot_6.5.1 devfs: v1.12c (20020818) Richard Gooch (rgooch@atnf.csiro.au) devfs: boot_options: 0x0 pty: 256 Unix98 ptys configured Serial driver version 5.05c (2001-07-08) with HUB-6 MANY_PORTS MULTIPORT SHARE_IRQ SERIAL_PCI enabled COMX: driver version 0.85 (C) 1995-1999 ITConsult-Pro Co. RAMDISK driver initialized: 16 RAM disks of 8192K size 1024 blocksize Initializing Cryptographic API NET4: Linux TCP/IP 1.0 for NET4.0 IP: routing cache hash table of 4096 buckets, 32Kbytes TCP: Hash tables configured (established 32768 bind 65536) Linux IP multicast router 0.06 plus PIM-SM RAMDISK: cramfs filesystem found at block 0 RAMDISK: Loading 3788 blocks [1 disk] into ram disk... |/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|/-\|done. Freeing initrd memory: 3788k freed VFS: Mounted root (cramfs filesystem). Freeing unused kernel memory: 96k freed NET4: Unix domain sockets 1.0/SMP for Linux NET4.0. Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4 ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx ide: late registration of driver. ALI15X3: IDE controller at PCI slot 00:0e.0 ALI15X3: chipset revision 197 ALI15X3: not 100% native mode: will probe irqs later ide0: BM-DMA at 0x1800-0x1807, BIOS settings: hda:DMA, hdb:pio ALI15X3: simplex device: DMA forced ide1: BM-DMA at 0x1808-0x180f, BIOS settings: hdc:DMA, hdd:DMA hda: HITACHI_DK14FA-20, ATA DISK drive ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx blk: queue df025b40, I/O limit 4095Mb (mask 0xffffffff) ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 hda: attached ide-disk driver. hda: 39070080 sectors (20004 MB) w/2048KiB Cache, CHS=38760/16/63, UDMA(100) Partition check: /dev/ide/host0/bus0/target0/lun0: [PTBL] [2432/255/63] p1 p2 < p5 p6 p7 > p3 Journalled Block Device driver loaded kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. kjournald starting. Commit interval 5 seconds EXT3-fs: mounted filesystem with ordered data mode. Adding Swap: 779112k swap-space (priority -1) EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,6), internal journal Real Time Clock Driver v1.10f SCSI subsystem driver Revision: 1.00 kjournald starting. Commit interval 5 seconds EXT3 FS 2.4-0.9.19, 19 August 2002 on ide0(3,7), internal journal EXT3-fs: mounted filesystem with ordered data mode. Linux Kernel Card Services 3.1.22 options: [pci] [cardbus] [pm] PCI: Assigned IRQ 3 for device 00:09.0 Yenta ISA IRQ mask 0x0080, PCI irq 3 Socket status: 30000006 8139too Fast Ethernet driver 0.9.26 PCI: Found IRQ 3 for device 00:0a.0 eth0: RealTek RTL8139 at 0x1400, XX:XX:XX:XX:XX:XX, IRQ 3 eth0: Identified 8139 chip type 'RTL-8100B/8139D' ALI 5455 + AC97 Audio, version 0.03-ac, 06:27:12 Sep 3 2004 ali_audio: Enabling S/PDIF at sample rate 48000Hz. ali_audio: Enabling S/PDIF at sample rate 48000Hz. ali_audio: Enabling S/PDIF at sample rate 48000Hz. ali_audio: Enabling controller S/PDIF at sample rate 48000Hz. PCI: Found IRQ 9 for device 00:04.0 ali: ALI 5455 found at IO 0x1000, IRQ 9 ac97_codec: AC97 Audio codec, id: ALG64 (Unknown) usb.c: registered new driver usbdevfs usb.c: registered new driver hub PCI: Found IRQ 5 for device 00:0f.0 usb-ohci.c: USB OHCI at membase 0xdf11f000, IRQ 5 usb-ohci.c: usb-00:0f.0, ALi Corporation USB 1.1 Controller usb.c: new USB bus registered, assigned bus number 1 hub.c: USB hub found hub.c: 2 ports detected PCI: Found IRQ 5 for device 00:0f.1 usb-ohci.c: USB OHCI at membase 0xdf121000, IRQ 5 usb-ohci.c: usb-00:0f.1, ALi Corporation USB 1.1 Controller (#2) usb.c: new USB bus registered, assigned bus number 2 hub.c: USB hub found hub.c: 2 ports detected hub.c: new USB device 00:0f.0-1, assigned address 2 usb.c: USB device 2 (vend/prod 0x46d/0xc00e) is not claimed by any active driver. hub.c: new USB device 00:0f.1-1, assigned address 2 usb.c: USB device 2 (vend/prod 0x4da/0xd01) is not claimed by any active driver. PCI: Found IRQ 6 for device 00:0f.3 IRQ routing conflict for 00:0f.3, have irq 11, want irq 6 ehci_hcd 00:0f.3: ALi Corporation USB 2.0 Controller ehci_hcd 00:0f.3: irq 11, pci mem df128400 usb.c: new USB bus registered, assigned bus number 3 ehci_hcd 00:0f.3: USB 2.0 enabled, EHCI 1.00, driver 2003-Dec-29/2.4 hub.c: USB hub found hub.c: 6 ports detected usb.c: USB disconnect on device 00:0f.0-1 address 2 usb.c: USB disconnect on device 00:0f.1-1 address 2 8139cp: 10/100 PCI Ethernet driver v1.2 (Mar 22, 2004) pci_hotplug: PCI Hot Plug PCI Core version: 0.5 shpchp: acpi_shpchprm:get_device PCI ROOT HID fail=0x1001 pci_hotplug: PCI Hot Plug PCI Core version: 0.5 pciehp: acpi_pciehprm:get_device PCI ROOT HID fail=0x1001 hub.c: new USB device 00:0f.1-1, assigned address 3 usb.c: USB device 3 (vend/prod 0x4da/0xd01) is not claimed by any active driver. hub.c: new USB device 00:0f.0-1, assigned address 3 usb.c: USB device 3 (vend/prod 0x46d/0xc00e) is not claimed by any active driver. eth0: link up, 100Mbps, full-duplex, lpa 0x45E1 usb.c: registered new driver hiddev usb.c: registered new driver hid Initializing USB Mass Storage driver... usb.c: registered new driver usb-storage input: USB HID v1.10 Mouse [Logitech USB-PS/2 Optical Mouse] on usb1:3.0 hid-core.c: v1.8.1 Andreas Gal, Vojtech Pavlik hid-core.c: USB HID support drivers mice: PS/2 mouse device common for all mice usb_control/bulk_msg: timeout scsi0 : SCSI emulation for USB Mass Storage devices cs: IO port probe 0x0100-0x04ff: excluding 0x480-0x48f 0x4d0-0x4d7 cs: IO port probe 0x0800-0x08ff: clean. cs: IO port probe 0x0c00-0x0cff: clean. cs: IO port probe 0x0a00-0x0aff: clean. vga16fb: initializing vga16fb: mapped to 0xc00a0000 Console: switching to colour frame buffer device 80x30 fb0: VGA16 VGA frame buffer device